Components and Calculation for Overhead Sliding Gates
1. Roller Carriages
2. Upper Track
3. Mounting Brackets
4. End Cap
5. Upper Stopper
6. Lower Stopper
7. Guide Rollers
8. U-Profile (Lower)
9. Lower Catcher
Enter the entrance width, and the calculator will instantly select a kit for weight categories: up to 300, 500, or 1000 kg.
Drawing Instructions:
- Frame: Overlaps the opening by 10 cm on each side.
- Rollers: Outer carriages (А5) are installed with a 35 cm offset from the frame edge. If more than 2 carriages are used, distribute the others evenly between points А5.
- Track: Divided into two zones (А5 and А5.1). It is recommended to install an additional bracket in the gap between them for rigidity.
- Safety: Always install stoppers (#5) inside the track to prevent the gate from falling out.
KSV Lower Stabilization
The U-profile protects rubber rollers from UV rays and weather. The system eliminates play and ensures smooth movement.
The U-profile protects rubber rollers from UV rays and weather. The system eliminates play and ensures smooth movement.
Gap Adjustment
The upper gap between the frame and the track can be any size (from 1 mm) — it is adjusted by the carriage-to-frame mounting type.
The upper gap between the frame and the track can be any size (from 1 mm) — it is adjusted by the carriage-to-frame mounting type.
Important: If the calculated gap between zones А5 and А5.1 is large, reinforce the track with an additional bracket.
How to Order?
1. Dimensions
Enter width A1
Enter width A1
2. Calculation
Click "Calculate"
Click "Calculate"
3. Selection
Choose products
Choose products
4. Checkout
Complete order
Complete order